Unlock Microcontroller PIC18F6525 Eeprom

Unlock Microcontroller PIC18F6525 locked memory and recover the data from Eeprom, program from flash, duplicate the content to other blank MCU for the exactly same cloning;

Unlock Microcontroller PIC18F6525 Eeprom

Unlock Microcontroller PIC18F6525 Eeprom

High Performance RISC CPU:

External Memory Interface

Linear program memory addressing to 64 Kbytes

Linear data memory addressing to 4 Kbytes

1 Kbyte of data EEPROM

Up to 10 MIPs operation:

– DC – 40 MHz osc./clock input

 

(PIC18F8525/8621 Devices Only):

· Address capability of up to 2 Mbytes

· 16-bit interface

Analog Features:

– 4 MHz – 10 MHz osc./clock input with PLL active

· 16-bit wide instructions, 8-bit wide data path

· Priority levels for interrupts

· 31-level, software accessible hardware stack

· 8 x 8 Single-cycle Hardware Multiplier

Peripheral Features:

High current sink/source 25 mA/25 mA

Four external interrupt pins

Timer0 module: 8-bit/16-bit timer/counter

Timer1 module: 16-bit timer/counter

Timer2 module: 8-bit timer/counter

Timer3 module: 16-bit timer/counter

Timer4 module: 8-bit timer/counter

Secondary oscillator clock option – Timer1/Timer3

Two Capture/Compare/PWM (CCP) modules:

– Capture is 16-bit, max. resolution 6.25 ns (TCY/16)

– Compare is 16-bit, max. resolution 100 ns (TCY)

– PWM output: 1 to 10-bit PWM resolution

Three Enhanced Capture/Compare/PWM (ECCP) modules:

– Same Capture/Compare features as CCP

– One, two or four PWM outputs

– Selectable polarity

– Programmable dead time

– Auto-Shutdown on external event

– Auto-Restart

Master Synchronous Serial Port (MSSP) module with two modes of operation:

– 2/3/4-wire SPI™ (supports all 4 SPI modes)

– I2C™ Master and Slave mode

Two Enhanced USART modules:

– Supports RS-485, RS-232 and LIN 1.2

– Auto-Wake-up on Start bit

– Auto-Baud Rate Detect

Parallel Slave Port (PSP) module

· 10-bit, up to 16-channel Analog-to-Digital Converter (A/D):

– Auto-Acquisition

– Conversion available during Sleep

· Programmable 16-level Low-Voltage Detection (LVD) module:

– Supports interrupt on Low-Voltage Detection

· Programmable Brown-out Reset (BOR)

· Dual analog comparators:

– Programmable input/output configuration

Special Microcontroller Features:

· 100,000 erase/write cycle Enhanced Flash program memory typical

· 1,000,000 erase/write cycle Data EEPROM memory typical

· 1 second programming time

· Flash/Data EEPROM Retention: > 100 years

· Self-reprogrammable under software control

· Power-on Reset (POR), Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)

· Watchdog Timer (WDT) with its own On-Chip RC Oscillator for reliable operation

· Programmable code protection against IC breaking

· Power-saving Sleep mode

· Selectable oscillator options including:

– 4x Phase Lock Loop (PLL) – of primary oscillator

– Secondary Oscillator (32 kHz) clock input

· In-Circuit Serial Programming™ (ICSP™) via two pins

· MPLAB® In-Circuit Debug (ICD 2) via two pins


Tags: ,,,,,,,,,