Read Microcontroller PIC18F6585 Software

Read Microcontroller PIC18F6585 Software from embedded program memory, needs to extract firmware from MCU PIC18F6585 and break microcontroller pic18f6585 security fuse bit;

Read Microcontroller PIC18F6585 Software from embedded program memory, needs to extract firmware from MCU PIC18F6585 and break microcontroller pic18f6585 security fuse bit
Read Microcontroller PIC18F6585 Software from embedded program memory, needs to extract firmware from MCU PIC18F6585 and break microcontroller pic18f6585 security fuse bit

High-Performance RISC CPU:

· Source code compatible with the PIC16 and PIC17 instruction sets

· Linear program memory addressing to 2 Mbytes

· Linear data memory addressing to 4096 bytes

· 1 Kbyte of data EEPROM

· Up to 10 MIPs operation:

– DC – 40 MHz osc./clock input

– 4 MHz-10 MHz osc./clock input with PLL active

· 16-bit wide instructions, 8-bit wide data path

· Priority levels for interrupts

· 31-level, software accessible hardware stack

· 8 x 8 Single-Cycle Hardware Multiplier if Read clone atmel at89s8252 Microcontroller

External Memory Interface (PIC18F8X8X Devices Only):

· Address capability of up to 2 Mbytes

· 16-bit interface

High current sink/source 25 mA/25 mA

Four external interrupt pins

Timer0 module: 8-bit/16-bit timer/counter

Timer1 module: 16-bit timer/counter

Timer2 module: 8-bit timer/counter

Timer3 module: 16-bit timer/counter

Secondary oscillator clock option – Timer1/Timer3

One Capture/Compare/PWM (CCP) module:

– Capture is 16-bit, max. resolution 6.25 ns (TCY/16)

– Compare is 16-bit, max. resolution 100 ns (TCY)

– PWM output: PWM resolution is 1 to 10-bit

Enhanced Capture/Compare/PWM (ECCP) module:

– Same Capture/Compare features as CCP

– One, two or four PWM outputs

– Selectable polarity

– Programmable dead time

– Auto-shutdown on external event

– Auto-restart

Master Synchronous Serial Port (MSSP) module with two modes of operation:

– 3-wire SPI™ (supports all 4 SPI modes)

– I2C™ Master and Slave mode Enhanced Addressable USART module:

– Supports RS-232, RS-485 and LIN 1.2

– Programmable wake-up on Start bit

– Auto-baud detect Parallel Slave Port (PSP) module

Analog Features:

· Up to 16-channel, 10-bit Analog-to-Digital Converter module (A/D) with:

– Fast sampling rate

– Programmable acquisition time

– Conversion available during Sleep

· Programmable 16-level Low-Voltage Detection

(LVD) module:

– Supports interrupt on Low-Voltage Detection

· Programmable Brown-out Reset (BOR)

· Dual analog comparators:

– Programmable input/output configuration

· Message bit rates up to 1 Mbps

· Conforms to CAN 2.0B ACTIVE Specification

· Fully backward compatible with PIC18XXX8 CAN modules

· Three modes of operation:

– Legacy, Enhanced Legacy, FIFO

· Three dedicated transmit buffers with prioritization

· Two dedicated receive buffers

· Six programmable receive/transmit buffers

· Three full 29-bit acceptance masks

· 16 full 29-bit acceptance filters with dynamic association

· DeviceNet™ data byte filter support

· Automatic remote frame handling

· Advanced Error Management features


Tags: ,,,,,,,,,