IC Crack Service | MCU Crack Service | Microcontroller Unlock Service Provider

Read IC PIC18F2450 Program from the microcontroller’s flash and data from its eeprom, the code has been combined with the content from both of them, the IC extraction can be executed only after the status of MCU has been reset from encrypted to un-encrypted and firmware will be fully recover from it.

 

Universal Serial Bus Features:

· USB V2.0 Compliant

· Low speed (1.5 Mb/s) and full speed (12 Mb/s)

· Supports control, interrupt, isochronous and bulk transfers

· Supports up to 32 endpoints (16 bidirectional)

· 256-byte dual access RAM for USB

· On-chip USB transceiver with on-chip voltage regulator

· Interface for off-chip USB transceiver

Power-Managed Modes:

Run: CPU on, peripherals on

Idle: CPU off, peripherals on

Sleep: CPU off, peripherals off

Idle mode currents down to 5.8 ìA typical

Sleep mode currents down to 0.1 ìA typical

Timer1 oscillator: 1.8 ìA typical, 32 kHz, 2V

Watchdog Timer: 2.1 ìA typical

Two-Speed Oscillator Start-up

Flexible Oscillator Structure:

· Four Crystal modes, including High-Precision PLL for USB

· Two External Clock modes, up to 48 MHz

· Internal 31 kHz oscillator

· Secondary oscillator using Timer1 @ 32 kHz

· Dual oscillator options allow microcontroller and USB module to run at different clock speeds

· Fail-Safe Clock Monitor:

– Allows for safe shutdown if any clock stops

Peripheral Highlights:

High-current sink/source: 25 mA/25 mA

Three external interrupts

Three Timer modules (Timer0 to Timer2)

Capture/Compare/PWM (CCP) module:

– Capture is 16-bit, max. resolution 5.2 ns

– Compare is 16-bit, max. resolution 83.3 ns

– PWM output: PWM resolution is 1 to 10-bit

· Enhanced USART module:

– LIN bus support

· 10-bit, up to 13-channel Analog-to-Digital Converter module (A/D):

– Up to 100 ksps sampling rate

– Programmable acquisition time

Special Microcontroller Features:

· C compiler optimized architecture with optional extended instruction set

· Flash memory retention: > 40 years

· Self-programmable under software control

· Priority levels for interrupts

· 8 x 8 Single-Cycle Hardware Multiplier

· Extended Watchdog Timer (WDT):

– Programmable period from 4 ms to 131s

· Programmable Code Protection

· Single-Supply In-Circuit Serial Programming™ (ICSP™) via two pins

· In-Circuit Debug (ICD) via two pins

· Optional dedicated ICD/ICSP port (44-pin TQFP devices only)

· Wide operating voltage range (2.0V to 5.5V)

Tags: read ic flash archive,read ic flash code,read ic flash content,read ic flash data,read ic flash eeprom,read ic flash file,read ic flash firmware,read ic flash information,read ic flash memory,read ic flash program