We can Hack PIC MCU Microchip CF745 Archive, please view the PIC MCU features for your reference:
Devices Included in this Data Sheet:
12-bit wide instructions for Hack PIC MCU
Seven or eight special function hardware registers
Two-level deep hardware stack
Direct, indirect and relative addressing modes for data and instructions
Peripheral Features:
· 8-bit real time clock/counter (TMR0) with 8-bit programmable prescaler when Hack PIC MCU
· Device Reset Timer (DRT)
Note:
The letter “s” used following the part numbers throughout this document indicate plural, meaning there is more than one part variety for the indicated device.
· Watchdog Timer (WDT) with its own on-chip RC oscillator for reliable operation
· Programmable code-protection for the purpose of Hack PIC MCU
High-Performance RISC CPU:
· Only 33 single word instructions to learn
· All instructions are single cycle (200 ns) except for program branches which are two-cycle
· Operating speed: DC – 20 MHz clock input DC – 200 ns instruction cycle
· Power saving SLEEP mode
· Selectable oscillator options:
– RC: Low-cost RC oscillator when Hack PIC MCU
– XT: Standard crystal/resonator
– HS: High-speed crystal/resonator
– LP: Power saving, low-frequency crystal
CMOS Technology:
· Low-power, high-speed CMOS EPROM/ROM technology
· Fully static design if Hack PIC MCU
· Wide-operating voltage and temperature range:
– EPROM Commercial/Industrial 2.0V to 6.25V
– ROM Commercial/Industrial 2.0V to 6.25V
– EPROM Extended 2.5V to 6.0V
– ROM Extended 2.5V to 6.0V
· Low-power consumption
– 15 µA typical @ 3V, 32 kHz
– < 0.6 µA typical standby current
(with WDT disabled) @ 3V, 0°C to 70°C
Note:
In this document, figure and table titles refer to all varieties of the part number indicated, (i.e., The title “Figure 14-1:
Load Conditions – PIC16C54A”, also refers to PIC16LC54A and PIC16LV54A