Crack Microcontroller PIC10F200 and extract code from encrypted MCU PIC10F200, the restored source code from PIC10F200 can be reprogrammed to new MCU;
High-Performance RISC CPU:
· Only 33 single-word instructions to learn
· All single-cycle instructions except for program branches, which are two-cycle
· 12-bit wide instructions
· 2-level deep hardware stack
· Direct, Indirect and Relative Addressing modes for data and instructions
· 8-bit wide data path
· 8 Special Function Hardware registers
· Operating speed:
– 4 MHz internal clock
– 1 ìs instruction cycle
Special Microcontroller Features:
· 4 MHz precision internal oscillator:
– Factory calibrated to ±1%
· In-Circuit Serial Programming™ (ICSP™)
· In-Circuit Debugging (ICD) support
· Power-on Reset (POR)
· Device Reset Timer (DRT)
· Watchdog Timer (WDT) with dedicated on-chip RC oscillator for reliable operation
· Programmable code protection
· Multiplexed MCLR input pin
· Internal weak pull-ups on I/O pins
· Power-Saving Sleep mode
· Wake-up from Sleep on pin change
Low-Power Features/CMOS Technology:
· Operating Current:
– < 175 ìA @ 2V, 4 MHz, typical
· Standby Current:
– 100 nA @ 2V, typical
· Low-power, high-speed Flash technology:
– 100,000 Flash endurance
– > 40 year retention
· Fully static design
· Wide operating voltage range: 2.0V to 5.5V
· Wide temperature range:
– Industrial: -40°C to +85°C
– Extended: -40°C to +125°C
Peripheral Features (PIC10F200/202):
· 4 I/O pins:
– 3 I/O pins with individual direction control
– 1 input-only pin
– High current sink/source for direct LED drive
– Wake-on-change
– Weak pull-ups
· 8-bit real-time clock/counter (TMR0) with 8-bit programmable prescaler
Peripheral Features (PIC10F204/206):
· 4 I/O pins:
– 3 I/O pins with individual direction control
– 1 input-only pin
– High current sink/source for direct LED drive
– Wake-on-change
– Weak pull-ups
· 8-bit real-time clock/counter (TMR0) with 8-bit programmable prescaler
· 1 Comparator:
– Internal absolute voltage reference
– Both comparator inputs visible externally
– Comparator output visible externally
The PIC10F200/202/204/206 devices from Microchip
Technology are low-cost, high-performance, 8-bit, fully-static, Flash-based CMOS microcontrollers. They employ a RISC architecture with only 33 single-word/single-cycle instructions. All instructions are single cycle (1 ìs) except for program branches, which take two cycles. The PIC10F200/202/204/206 devices deliver performance in an order of magnitude higher than their competitors in the same price category.
The 12-bit wide instructions are highly symmetrical, resulting in a typical 2:1 code compression over other 8-bit microcontrollers in its class. The easy-to-use and easy to remember instruction set reduces development time significantly.