Crack MCU dsPIC30F4011 Binary can help to disable the microcontroller security fuse bit and readout the program and data from the microcontroller in the format of binary or heximal;
High-Performance, Modified RISC CPU:
· Modified Harvard architecture
· C compiler optimized instruction set architecture with flexible addressing modes
· 83 base instructions
· 24-bit wide instructions, 16-bit wide data path
· 48 Kbytes on-chip Flash program space (16K instruction words)
· 2 Kbytes of on-chip data RAM
· 1 Kbyte of nonvolatile data EEPROM
· Up to 30 MIPS operation:
– DC to 40 MHz external clock input
– 4 MHz-10 MHz oscillator input with PLL active (4x, 8x, 16x)
· 30 interrupt sources:
– 3 external interrupt sources
– 8 user-selectable priority levels for each interrupt source
– 4 processor trap sources
· 16 x 16-bit working register array
DSP Engine Features:
· Dual data fetch
· Accumulator write-back for DSP operations
· Modulo and Bit-Reversed Addressing modes
· Two, 40-bit wide accumulators with optional saturation logic
· 17-bit x 17-bit single-cycle hardware fractional/integer multiplier
· All DSP instructions are single cycle
· ±16-bit, single-cycle shift
Peripheral Features:
· High-current sink/source I/O pins: 25 mA/25 mA
· Timer module with programmable prescaler:
– Five 16-bit timers/counters; optionally pair 16-bit timers into 32-bit timer modules
· 16-bit Capture input functions
· 16-bit Compare/PWM output functions
· 3-wire SPI modules (supports 4 Frame modes)
· I2C™ module supports Multi-Master/Slave mode and 7-bit/10-bit addressing
· 2 UART modules with FIFO Buffers
· 1 CAN module, 2.0B compliant
Motor Control PWM Module Features:
· 6 PWM output channels:
– Complementary or Independent Output modes
– Edge and Center-Aligned modes
· 3 duty cycle generators
· Dedicated time base
· Programmable output polarity
· Dead-time control for Complementary mode
· Manual output control
· Trigger for A/D conversions
Analog Features:
· 10-Bit Analog-to-Digital Converter (A/D) with 4 S/H inputs:
– 1 Msps conversion rate
– 9 input channels
– Conversion available during Sleep and Idle
· Programmable Brown-out Reset
Special Digital Signal Controller Features:
· Enhanced Flash program memory:
– 10,000 erase/write cycle (min.) for industrial temperature range, 100K (typical)
· Data EEPROM memory:
– 100,000 erase/write cycle (min.) for industrial temperature range, 1M (typical)
· Self-reprogrammable under software control when Crack MCU
· Power-on Reset (POR), Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)