Break Microprocessor IC Microchip PIC16LF88

We can Break Microprocessor IC Microchip PIC16LF88 – 18/20/28-Pin Enhanced FLASH Microprocessors IC with nanoWatt Technology, please view the IC chip features for your reference:

Low-Power Features:

· Power Managed modes:

– Primary RUN: RC oscillator, 76 µA, 1 MHz, 2V

– RC_RUN: 7 µA, 31.25 kHz, 2V

– SEC_RUN: 9 µA, 32 kHz, 2V

– SLEEP: 0.1 µA, 2V

· Timer1 Oscillator: 1.8 µA, 32 kHz, 2V

· Watchdog Timer: 2.2 µA, 2V

· Two-Speed Oscillator Start-up

Oscillators:

· Three Crystal modes:

– LP, XT, HS: up to 20 MHz

· Two External RC modes

· One External Clock mode:

 

RA2/AN2/CVREF/ VREF-RA3/AN3/VREF+/C1OUT RA4/AN4/T0CKI/ C2OUT RA5/MCLR/VPP VSS RB0/INT/CCP1(1 RB1/SDI/SDA RB2/SDO/RX/DT- ECIO: up to 20 MHz

· Internal oscillator block:

– 8 user selectable frequencies: 31 kHz,

 

Note 1:

 

The CCP1 pin is determined by CCPMX in Configuration Word 1 register.

 

125 kHz, 250 kHz, 500 kHz, 1 MHz, 2 MHz,

4 MHz, 8 MHz

Peripheral Features:

· Capture, Compare, PWM (CCP) module:

– Capture is 16-bit, max. resolution is 12.5 ns

– Compare is 16-bit, max. resolution is 200 ns

– PWM max. resolution is 10-bit

· 10-bit, 7-channel Analog-to-Digital Converter

· Synchronous Serial Port (SSP) with SPI™

(Master/Slave) and I2C™ (Slave)

· Addressable Universal Synchronous

Asynchronous Receiver Transmitter

(USART/SCI) with 9-bit address detection:

– RS-232 operation using internal oscillator

(no external crystal required)

· Dual Analog Comparator module:

– Programmable on-chip voltage reference

– Programmable input multiplexing from device

inputs and internal voltage reference

– Comparator outputs are externally accessible

 

Special Microcontroller Features:

· 100,000 erase/write cycles Enhanced FLASH

program memory typical

· 1,000,000 typical erase/write cycles EEPROM

data memory typical

· EEPROM Data Retention: > 40 years

· In-Circuit Serial Programming™ (ICSP™) – via two pins

· Processor read/write access to program memory

· Low-Voltage Programming

· In-Circuit Debugging via two pins

· Extended Watchdog Timer (WDT):

Programmable period from 1 ms to 268s

· Wide operating voltage range: