-
Product Categories
Live Support Chat
Microchip PIC18F26K40 MCU Firmware Program Cloning
Microchip PIC18F26K40 MCU Firmware Program Cloning needs to break microchip microprocessor pic18f26k40 flash memory security fuse bit, and then extract the code from protected microcontroller pic18f26k40;
The Complementary Waveform Generator (CWG) produces half-bridge, full-bridge, and steering of PWM waveforms. It is backwards compatible with previous CCP functions when crack microcontroller pic18f25k40t secured memory. The PIC18(L)F25/26K83 family has three instances of the CWG module.
Each of the CWG modules has the following features:
- Six operating modes:
- Synchronous Steering mode
- Asynchronous Steering mode
- Full-Bridge mode, Forward
- Full-Bridge mode, Reverse
- Half-Bridge mode
- Push-Pull mode
- Output polarity control
- Output steering
- Independent 6-bit rising and falling event dead- band timers
- Clocked dead band
- Independent rising and falling dead-band enables
- Auto-shutdown control with:
- Selectable shutdown sources
- Auto-restart option
Auto-shutdown pin override control
The CWG generates two output waveforms from the selected input source.
The off-to-on transition of each output can be delayed from the on-to-off transition of the other output, thereby, creating a time delay immediately where neither output is driven. This is referred to as dead time and is covered in Section 26.6 “Dead-Band Control”.
It may be necessary to guard against the possibility of circuit faults or a feedback event arriving too late or not at all. In this case, the active drive must be terminated before the Fault condition causes damage. This is referred to as auto-shutdown and is covered in Section26.10 “Auto-Shutdown”.