Crack MCU ATtiny861 Flash

Crack MCU ATtiny861 flash memory and extract firmware out from Flash and eeprom memory, in order to unlock the Microcontroller, hacker needs to get access to its databus which connect the processor CPU and memory, then extract the source code from it, the whole process will normally take no longer than 3 hours;

 

Crack MCU ATtiny861 flash memory and extract firmware out from Flash and eeprom memory, in order to unlock the Microcontroller, hacker needs to get access to its databus which connect the processor CPU and memory

Crack MCU ATtiny861 flash memory and extract firmware out from Flash and eeprom memory, in order to unlock the Microcontroller, hacker needs to get access to its databus which connect the processor CPU and memory

· Utilizes the AVR® RISC Architecture

· High-performance and Low-power 8-bit RISC Architecture

– 90 Powerful Instructions – Most Single Clock Cycle Execution

– 32 x 8 General Purpose Working Registers

– Up to 8 MIPS Throughput at 8 MHz

Nonvolatile Program and Data Memory which provide difficult for MCU reading

– 1K Byte of Flash Program Memory

In-System Programmable (ATTINY861)

Endurance: 1,000 Write/Erase Cycles (ATTINY861)

– 64 Bytes of In-System Programmable EEPROM Data Memory for ATTINY861

Endurance: 100,000 Write/Erase Cycles

– Programming Lock for Flash Program and EEPROM Data Security

Peripheral Features

– Interrupt and Wake-up on Pin Change

– One 8-bit Timer/Counter with Separate Prescaler

– On-chip Analog Comparator

– Programmable Watchdog Timer with On-chip Oscillator

Special Microcontroller Features

– Low-power Idle and Power-down Modes

– External and Internal Interrupt Sources

– In-System Programmable via SPI Port (ATTINY861)

– Enhanced Power-on Reset Circuit (ATTINY861)

– Internal Calibrated RC Oscillator (ATTINY861)

Specification

– Low-power, High-speed CMOS Process Technology

– Fully Static Operation

Power Consumption at 4 MHz, 3V, 25°C

– Active: 2.2 mA

– Idle Mode: 0.5 mA

– Power-down Mode: <1 µA

Packages

– 8-pin PDIP and SOIC

Operating Voltages

– 1.8 – 5.5V for ATtiny12V-1

– 2.7 – 5.5V for ATTINY861

– 4.0 – 5.5V for ATTINY861

Speed Grades


Tags: ,,,,,,,,,,,